Frameworks & control

Inherent limitations of internal control

Inherent limitations of internal control are the limits that every system of internal control has, even when it is well designed and operating, which mean that it provides reasonable but not absolute assurance that objectives will be achieved. COSO Internal Control: Integrated Framework (2013) mentions, among others, human error, management override, collusion and events beyond the organisation's control.

Source: COSO Internal Control: Integrated Framework (2013), Executive Summary (Limitations); Dutch Corporate Governance Code 2025, principle 1.4 and best practice provisions 1.2.3, 1.4.2 and 1.4.3 with explanatory notes; IIA Netherlands, Practice Guide VOR en de Internal Auditfunctie (2024)

In its Executive Summary, COSO names six sources of limitations: the suitability of the objectives established as a precondition to internal control, human judgement that can be faulty or biased, breakdowns caused by human failures, the ability of management to override internal control, the circumvention of controls through collusion by management, other personnel or third parties, and external events. Internal control cannot prevent bad judgement or decisions, and even an effective system can fail. Management should be aware of the limitations and minimise them as far as practical when selecting controls.

For the management board of a listed company, the limitations are part of its accountability. The explanatory notes to principle 1.4 of the Dutch Corporate Governance Code 2025 state that the Statement on Risk Management (Verklaring omtrent Risicobeheersing, VOR) does not provide absolute assurance, but control of the material risks that fits the strategy and risk appetite. According to the explanatory notes to best practice provision 1.4.3, it is to be expected that the statement in any case addresses the inherent limitations of the systems, and the management board may state that certain risks by their nature cannot be managed effectively. In its 2024 Practice Guide on the VOR, the Institute of Internal Auditors Netherlands (IIA Netherlands) lists the inherent limitations as a point of attention when determining the level of assurance. The Code applies on a comply or explain basis.

Inherent limitations are not the same as inherent risk, the risk before controls. Nor are they a deficiency: an error that occurs despite well designed and operating controls does not in itself mean that the system falls short. Management override and collusion are two of the limitations; the management board can reduce them, for example through detection across processes, a reporting procedure and oversight by the supervisory board and audit committee, but cannot eliminate them.

Last updated: · Editor: ONE Risk Advisory

Frequently asked questions

Must the management board mention the inherent limitations in the Statement on Risk Management (VOR)?

According to the explanatory notes to best practice provision 1.4.3 of the Dutch Corporate Governance Code 2025, it is to be expected that the statement in any case addresses the responsibilities of the management board, the objectives, the characteristics and the inherent limitations of the systems. This is an expectation in the notes, not a separate part of the provision; the Code itself applies to listed companies on a comply or explain basis.

Does an incident mean that internal control was not effective?

Not in itself. According to COSO Internal Control: Integrated Framework (2013), even an effective system can fail, for example through collusion or an external event. The management board does examine the cause and takes the lessons learned into its annual assessment (best practice provision 1.2.3). If design or operation was at fault, it may be a major deficiency to be reported under provision 1.4.2 under iv.

What is the difference between inherent limitations and inherent risk?

Inherent risk is the risk that exists before controls. Inherent limitations concern the controls themselves: even when they are well designed and operating, they may fail through human error, management override, collusion or external events. As a result, some residual risk always remains after control.

← All terms